Simoniz 039-8578-4 Instrucciones de operaciones descargar pdf (Pagina 20)

Maximum Pressure

3200 PSI

Rated Water Pressure

2500 PSI

Maximum Water Flow

10 litres per minute

LPM (2.6 gallons

per minute GPM)

Minimum Inlet Pressure

30 PSI

Maximum Inlet Pressure

100 PSI

Pump Type

Heavy-duty main-

tenance free axial

cam

Thermal Relief Valve

Included

Detergent Tank (Vo-

lume)

0.75 L each (0.2

Gal)

Maximum Temperature

of Pumped Water

40℃ (104℃)

Engine Power (OHV)

6.5 HP

No Load Speed

3600 RPM

High Pressure Hose

Length

15 m (50')

Inlet & Discharge Ports

13 mm (3/4")

standard garden

hose connector

Displacement

196 (cc)

Net Weight

38 kg (83.8 lbs)

Oil Type

SAE 10W30

Oil Capacity

0.6 L

Fuel Type

Unleaded Gasoline

Fuel Tank

3.8 L

Cleaning and Maintenance/Technical Specifications

LEANING AND

AINTENANCE

• Make sure the engine

I/O

switch (12) is set to

position. Slowly pull the starter cord handle

(7) until you feel tension, which indicates the

piston is on its compression stroke and leave it

in this position.

• Replace the spark plug.

7.5 Winterizing Procedures

• Pressure washer might be damaged if sub-

jected to freezing temperatures. This type of

damage is not covered by the limited warranty.

To avoid possible damages, use a small

amount of antifreeze.

• Place the pressure washer on its side, with

the water inlet (17) facing upwards, and pour

1/4 cup of antifreeze into the water inlet (17).

• Make sure the engine

I/O

switch (12) is set to

position and pull the starter cord handle (7)

several times to distribute the antifreeze inside

the pump system.

• When taking the pressure washer out of sto-

rage, run water through the system until it runs

clear.

IMPORTANT

• If the pressure washer is to be stored with gasoline

in the fuel tank and carburetor, it is important to re-

duce the hazard of gasoline vapor ignition.

• Select a well-ventilated storage area away from any

appliance that operates with a flame, such as a

furnace, water heater, or clothes dryer. Also avoid

any area with a spark-producing electric motor, or

where power tools are operated.

• If possible, avoid storage areas with high humidity,

because that promotes rust and corrosion.

• Place the pressure washer on a level surface. Tilting

can cause fuel or oil leakage.

• Do not use plastic sheets as a dust cover. A non-

porous cover will trap moisture around the pressure

washer, promoting rust and corrosion.

ECHNICAL

PECIFICATIONS

1 2 ... 15 16 17 18 19 20 21 22 23 24 25

Comentarios a estos manuales

Sin comentarios

Simoniz 039-8578-4 Instrucciones de operaciones Pagina 20

Comentarios a estos manuales